Elastomeric Plastic Cement Concrete Grey Français
Description
This new generation shrinkage free elastomeric colored plastic cement CR-314 is excellent to repair cracks in concrete, masonry, asphalt pavement, wood, gutters, asphalt shingles and metal roofs. Low in VOC, this elastomeric putty can be used to glue back asphalt shingles, seal chimney and vents, flashing. Recommended to repair before applying Sealflex Elastomeric Coating.
Surface Preparation
Clean surface with an universal degreaser (except for asphalt singles), brush and then rinse thoroughly. Sand smooth surfaces to get more adhesion. In certain cases, clean with a high pressure washer unit to ensure that all surfaces are sound, clean and free of rust, flaking paint, dust, dirt, grease and mildew. Let dry before product application.
Application
Avoid application under a full sun or on a very hot surface. Test on a small area to see if material is appropriate. It can be applied with a putty knife, a trowel or a caulking gun. It is important to close container between each use. We need a temperature higher than 10 º C. Protect surfaces against rain until product has completely dried. Surfaces must be repaired in a way to ensure water drainage. For cracks of a maximum of 1.27 cm (½'') wide by 1.27 cm (½'').
Yield

100% acrylic and odorless. Super flexible. Interior or exterior application. Several colors available. Can be painted. Resists to cracking and UV. Silicone modified.

Cleanning
Clean tools with water while product is still fresh.
Package
This product is available in 1kg and 300 ml.
Storage
Keep from freezing. This product can be preserved in its original container, sealed for 1 year from date of purchase.
Technical Data Table
Specifications  
Color Concrete Grey
Solid content 75 to 80 %
Density About 1,5 kg/L (12,5 lb/gal)
PH 8.5 to 9.0
Coverage 0,14 m² (1,48 ft²) by Kg for 6mm (1/4'') thickness
Drying time To 50 % H.R. 20° C (68° F)
To the toutch About 20 minutes
Completely dry 24 to 48 hours
Service temperature - 40° C to 90° C 
(- 40° F to 195° F)
Application temperature minimum 10° C (50° F)
Chemical resistance Resist to most popular acids, alkalis, greases and solvents
Permeance to water
(ASTM E96) Permeable
  175%
Strength at rupture 
(ASTM D412) 620 kPa (90 PSI)
 

* Drying Time depend of surface porosity and temperature.

Warranty
10 years limited warranty when installed and / or applied as recommended by the manufacturer. We will replace the product with a manufacturing defect. Under no circumstances will the manufacturer be liable for any amount in excess of the purchase price of the product used. The consumer must ensure that this product is suitable for the intended use. Because of atmospheric conditions, applicator competence and surface conditions being independent of the manufacturer's control, we limit our liability for one year following the date of purchase, with proof of purchase, to replacement of defective material only in its original hermetic container. Port paid factory (FAB factory).

Elastomeric Plastic Cement
Elastomeric Plastic Cement
Ecologic
Warning Simdut

MAY IRRITATE EYES AND SKIN. Do not get in eyes, on skin or on clothing. Keep out of reach of children.


FIRST AID TREATMENT: Contains Stoddard solvent. If swallowed, call a Poison Control Centre or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, clean with mineral oil followed by soapy water then rinse well.
 
PDFdownload PDF version