Elastomeric Plastic Cement White Français
This new generation shrinkage free colored Elastomeric Plastic Cement CR-316 repairs cracks in concrete, masonry, asphalt pavement, wood, gutters, asphalt shingles and metal roofs. Low in VOC, this elastomeric putty can be used to glue back asphalt shingles,seal chimney, vents and flashings. Recommended to repairs before applying Sealflex Elastomeric Coating.
Surface Preparation
Clean surface with an universal degreaser (except for asphalt singles). Brush and then rinse thoroughly. Sand smooth surfaces to get more adhesion. In certain cases, clean with a high pressure washer unit to ensure that all surfaces are sound, clean and free of rust, flaking paint, dust, dirt, grease and mildew. Let dry before product application.
Avoid application under a full sun or on a very hot surface.Test on a small area to see if material is appropriate. You can use a putty knife, a trowel or a caulking gun. It is important to close container between each use. We need a temperature higher than 10 º C. Protect surfaces against rain until product has completely dried. Surfaces must be repaired in a way to ensure water drainage. To repair cracks having a maximum of 1.27 cm (½'') wide by 1.27 cm (½'').

100% acrylic and odorless. Super flexible. Interior or exterior application . Several colors available. Can be painted. Resists to cracking and UV. Silicone modified

Clean tools with water while product is still fresh.
This product is available in 1kg and 300 ml.
Keep from freezing.
Shelf Life
This product can be preserved in its original container, sealed for 1 year from date of purchase.
Technical Data Table
Color White
Solid content 75 to 80 %
Density About 1,5 kg/L (12,5 lb/gal)
PH 8.5 to 9.0
Coverage 0,14 m² (1,48 ft²) by Kg for 6mm (¼'') thickness
Drying time To 50 % H.R. 20° C (68° F)
To the toutch About 20 minutes
Completely dry 24 to 48 hours
Service temperature - 40° C to 90° C 
(- 40° F to 195° F)
Application temperature minimum 10° C (50° F)
Chemical resistance Resist to most popular acide, alcalis, grease and solvants.
Permeance to Water Vapor (ASTM E96) Permeable
Permeance to rupture 
(ASTM D412) 175%
Strength at rupture 
(ASTM D412) 620 kPa (90 PSI)

* Drying Time depend of surface porosity and temperature.

10 years limited warranty when installed and / or applied as recommended by the manufacturer. We will replace the product with a manufacturing defect. Under no circumstances will the manufacturer be liable for any amount in excess of the purchase price of the product used. The consumer must ensure that this product is suitable for the intended use. Because of atmospheric conditions, applicator competence and surface conditions being independent of the manufacturer's control, we limit our liability for one year following the date of purchase, with proof of purchase, to replacement of defective material only in its original hermetic container. Port paid factory (FAB factory).

Elastomeric Plastic Cement
Elastomeric Plastic Cement

May cause cancer. Causes damage to organs through prolonged or repeated exposure.

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust/fumes/gas/mist/vapours/spray. Wash exposed and/or contaminated area thoroughly after handling. Do not eat, drink or smoke when using this product. Wear protective gloves/protective clothing/eye protection/face protection.

If exposed: Call a POISON CENTER or doctor/physician. Get medical advice/attention if you feel unwell. Store locked up. Dispose of contents / container by a local waste disposal company according to regional regulations.

PDFdownload PDF version