Insulation Panel Grip Français
Description
CR400 is an acrylic latex adhesive for insulation panels. It has a strong initial adhesion and sets rapidly to offer a resistant and flexible hold. Specially formulated for rigid insulation panels installations on concrete, wood, masonry or any other porous materials.
Surface Preparation
Surfaces must be even, clean, dry and free of dust, rust, oil, grease, frost, flaky paint or from any contaminants that might decrease adhesion. Use the Fondafix product to level imperfection on concrete or masonry walls to obtain uniform surfaces.
Application
Notched trowel: Apply with a 3 mm (1/8'') V-notched trowel (recommended method to bond polystyrene panel or gypsum panels to insulation surfaces, see restrictions). In bead: Apply a 12 mm (1/2'') diameter bead at 150 mm (6'') between axles forming a serpentine. In drops: Apply nut-sized drops every 150 mm (6''). Once flattened out, the drops will have 40 to 50 mm (1 1/2 to 2'') diameter. Set the insulation panel in place by firmly pressing in several areas for maximum contacts. Note: Joints must be seal to prevent air infiltration behind insulation panels. Drying time depends on application method, temperature and surface porosity
Cleanning
Clean tools and equipment with water.
Norm
CAN/O.N.G.C. 71-GP-24M
Package
This product is available in tube of 300 ml or 1kg, 4kg and 20kg pail.
Storage
Keep from freezing
Shelf Life
12 months after purchasing date when kept in its tightly closed original container. Keep from freezing
Technical Data Table
Specifications  
Color Off-white
Solids by Volumes 75 to 80 %
Densité 1,5 kg/L (about) (12,5 lb/gal)
PH 8.5 to 9.5
Coverage 0,14 m² (1,48 ft²) / kg for coat of 6mm (¼in)
Dry time* At 50 % H.R. 20°C (68°F)
initial Set* 20 minutes (about)
Final Cure* 24 to 48 hours
Service Temperature Maximum 85°C (158°F) dry coating
Application Temperature minimum 10°C (50°F)
Permeance to Water Vapor (ASTM E96) Permeable
Permeance to rupture (ASTM D412) 175%
Strength at rupture (ASTM D412) 620 kPa (90 PSI)
 

* Drying Time depend of surface porosity and temperature.

Restriction
Do not apply gypsum or any other kind of coverings before the product is completely dried. Also check if adhesive is strong enough to support the weight. Do not use as an adhesive for mechanical fasteners.
Warranty

Insulation Panel Grip
Insulation Panel Grip
Ecologic
Warning Simdut

MAY IRRITATE EYES AND SKIN. Do not get in eyes, on skin or on clothing. Keep out of reach of children.


FIRST AID TREATMENT: Contains Stoddard solvent. If swallowed, call a Poison Control Centre or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, clean with mineral oil followed by soapy water then rinse well.
 
PDFdownload PDF version