Eagle Magic Patch Multi-Use Repair Mortar Français
Eagle Magic Patch is a one component polymer modified rapid-set cementitious mortar. It allows quick repairs at a variety of water ratio and at many thicknesses over old concrete imperfections. It can be applied very fluid with a broom-brush or more consistent for applications that can vary from 6 mm (1/4") to 75 mm (3") in one application. This mortar is specially formulated to recondition horizontal or sloped concrete jobs, inside or outside. Being concrete grey, this high performance polyvalent product can repair and/or give concrete surfaces a uniform nice new look. It can also be colored with ferrous oxide pigments.
Surface Preparation
All surfaces shall be structurally sound, clean and free from dust, oil, grease, wax, paint, curing agent, coatings and loose particles, acids, alkalis, chemical cleaning agent or any other material that can reduce adhesion. All concrete substrates shall be completely cured and at least 28 days old. They must be roughened for a good adhesion.
Avoid working under intense sun. Use of Eagle Prime Plus as primer is a good alternative to concrete water saturation otherwise, saturate concrete surface with clean water within few hours before repairs leaving no excess water. Apply mortar when surface is dry again. Ambient surface and product temperature must be superior than 10ºC (50ºF) and lower than 35ºC (95ºF) before installation and for the first 24 hours. Protect from rain or liquids for 24 hours.
In a clean container, depending of consistency desired, pour 200 to 250 ml of fresh clean water per kilogram of product. Add gradually Eagle Magic Patch powder while mixing with a low-speed drill and a mixer. Blend for 2 to 3 minutes scraping recipient walls and paddle to obtain a homogeneous trowelable lump-free consistency. Proceed for application and finishing.
Eagle Magic Patch takes 20 to 30 minutes to dry. Curing time may vary according to temperature and humidity level. Protect surface from rain, sun and wind but with a plastic sheeting, it must be done without any contact with the surface. It could alter the finish. Wait 2 to 3 hours prior to allow light traffic.
Clean working tools and hands with water while product is still fresh.
This product is available in 5 kg bag and 11.34 kg bag.
Shelf Life
Store in a dry and fresh area. Shelf life is 12 months in its original non-opened container.
Technical Data Table
Pot Life   15 minutes 23 minutes
Setting time initial / final ASTM C-191   18 minutes / 25 minutes 25 minutes / 45 minutes
Density ASTM C-185   2,01 kg/L 1,98 kg/L
Compressive strength ASTM C-109 4 hours
24 hours
7 days
28 days
14 MPa ( 2030 PSI) 20 MPa ( 2900 PSI) 31 MPa ( 4496 PSI) 35 MPa ( 5076 PSI) 12 MPa ( 1740 PSI) 15 MPa ( 2175 PSI) 31 MPa ( 4496 PSI) 37 MPa ( 5366 PSI)
Adhesive strength over concrete CSA A23.2-6B 7 days 28 days 1.91 MPa ( 277 PSI) 2.12 MPa ( 307 PSI) 2,08 MPa ( 301 PSI) 2.21 MPa ( 320 PSI)
Coverage by kg of product   0.09 m² at 6 mm thickness (1 ft² at 1/4'' thickness) 0.09 m² at 6 mm thickness (1 ft² at 1/4'' thickness)

* Drying Time depend of surface porosity and temperature.

The customer shall verify of the suitability of this product for the intended purpose. Applicator's skill, weather and surface conditions being beyond manufacturer's control, we limit our liability to replacement of defective material only in sealed container, within 1 year of proof of purchase. FOB plant.

Eagle Magic Patch
Eagle Magic Patch
Avertissement Simdut Simdut

CORROSIVE: This product contains a cementitious blend and may cause eyes, skin and respiratory system irritation. When using this product: Wear safety glasses, gloves and a NIOSH approved anti-dust mask. Keep out of reach of children.

FIRST AID TREATEMENT: Skin contact: Wash with soap and water. Eye contact: Flush eyes immediately and abundantly with water for 15 minutes keeping eyelids opened. Consult a physician immediately. Ingestion: DO NOT INDUCE VOMITING. Give water if conscious. Keep victim warm and call immediately a physician.
PDFdownload PDF version