Eagle Mastic Ceramic Adhesive Français
EAGLE MASTIC is an high quality 100% acrylic latex based adhesive. Off white and creamy for wall installation of natural stone and ceramic tile. This ready-to-use mastic is formulated for residential interior ceramic tile installation, for light traffic, horizontal or vertical surfaces. Non-toxic and non-flammable, it offers a very good adhesion on conventional substrates and metallic surfaces. Ceramic tiles up to 305 X 305 mm (12” X 12”) in dimension can be installed vertically with EAGLE MASTIC without any sagging. Once completely dry, it offers an excellent water resistance.
Surface Preparation
Take note that rigorous attention must be taken to execute surface preparation conform to trade practices and Eagle Black’s surface preparation guidelines.All surfaces shall be structurally sound, clean and free from traces of dust, oil, grease, wax, paint, curing agent, coatings and loose particles, acids, alkalis or any other material that can reduce adhesion. The only recommended wood substrate for residential floors is exterior grade plywood installed in an interior dry area. All concrete substrates shall be completely cured and at least 28 days old, free from hydrostatic conditions and/or humidity problems. They must be roughened to give better adherence. Gypsum Drywall panels and plaster joints must be primed with a coat of Eagle Prime Plus latex. Ambient surface and product temperature must be superior than 10ºC (50ºF)and lower than 35ºC (95ºF) before installation and for the first 48 hours.
Spread and press mastic on surface to be covered with flat edge of trowel. Quickly add mastic by using notched side of the trowel, spread mastic uniformly, taking care to trace ridge lines in the same straight line direction. For walls, trace ridges in horizontal direction. Prepare the quantity that can be applied in less than 20 minutes. If ridges have slightly dried and if there is skin formation at the surface, there will be no adherence. Mastic will have to be removed and a fresh coat applied. Press tiles firmly with a back and forth motion across ridges to obtain full mastic transfer at the back of tiles. Tiles must be embedded at 1/3 of their thickness in mastic. Never wet tiles prior to their application, if so, it must be advised by tile manufacturer.
Ready to use. Apply immediately with recommended trowel.

Approximate coverage for a 22.7 kg (50lb) bag :
Trowel from 6 X 6 X 6 mm (¼” X ¼” X ¼”) : 0.7 m² (7.5 pi²)
Trowel in V from 5 mm (3/16”) : .1.3 m² (14 pi²)

Protect surfaces for 48 hours. Curing time may vary according to temperature and humidity level. When installation is on a floor, make sure application is dry prior to allow light traffic for grouting.
Clean working tools and hands with water while product is still fresh.
Available in 1 L, 4 L et 13.25 L pails.
Store in a dry and fresh area. KEEP FROM FREEZING. Shelf life is 12 months in its original non-opened.
Technical Data Table
Open time to 23°C (73°F) About 45 minutes
Temps de Curing to 23°C (73°F) 24 to 48 hours
Flammability non-combustible
Shear Strenth (ANSI A136.1, Type 1) Override
Stability to freeze/thaw cycles up to -18°C (0°F)
Subsidence None
Specific weith (g/cm²) 1,4
pH 8,0 to 8,5
Cleannig With water
Color Whitish

* Drying Time depend of surface porosity and temperature.

The customer shall verify of the suitability of this product for the intended purpose. Applicator's skill, weather and surface conditions being beyond manufacturer's control, we limit our liability to replacement of defective material only in sealed container, within 1 year of proof of purchase. FOB plant.

Eagle Mastic
Eagle Mastic
Warning Simdut

MAY IRRITATE EYES AND SKIN. Do not get in eyes, on skin or on clothing. Keep out of reach of children.

FIRST AID TREATMENT: Contains Stoddard solvent. If swallowed, call a Poison Control Centre or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, clean with mineral oil followed by soapy water then rinse well.
PDFdownload PDF version