N.I.S. Adhesive CR-50
The CR50 is an N.I.S. Adhesive. This product is used in cold processes to stick N.I.S. roofing papers, felt papers and asphalt paper. Its composition gives it a very strong adhesion on all types of surfaces without altering the composition of bonded materials. Its semi-liquid consistency is ideal for sticking asphalt shingles, protecting them from breakage caused by wind.
Do you want to buy this product?
Function
Stick
Building Components
Roofing
Surfaces
N.I.S. paper / Asphalt paper / Asphalt shingle / Felt paper
Coverage
1 m²/L (40 ft²/gallon)
Color
Black
Application Temperature
10°C and more preferably. The product will be thicker when the temperature decreases.
Service Temperature
-40°C to 85°C
Application Tools
Paint brush / Brush / Roller / Squeegee
Surface Preparation
Surfaces must be clean and free of dust, dirt or other contaminants. Repair the surfaces with plastic cement from Condor.
Application
Do not apply if rain is expected. During colder periods, keep the product in a temperate place to facilitate its application. Stir well before application. Apply the product in an even and thin layer. Close the container after each use.
Drying
Allow about 4h for surface drying and about 48h for complete drying. The drying time depends on the application method, the ambient temperature, the surface and the thickness applied.
Restriction / Caution
Avoid contact with polystyrene foam insulation boards. Do not apply on wet surfaces. Keep out of the reach of children. If the product is applied near a ventilation or air conditioning unit, take the necessary precautions to prevent infiltration of solvent odours toward the inside. Keep open container or freshly applied product away from open flames, sparks or other sources of heat. For outdoor use only.
Cleaning
Mineral spirits
Storage
The product may be kept in its original sealed container up to 12 months after the date of purchase by the user.
- 3,78L
- 18,9L
5 years limited warranty when installed and / or applied as recommended by the manufacturer. We will replace the product with a manufacturing defect. Under no circumstances will the manufacturer be liable for any amount exceeding the purchase price of the product used. The consumer must ensure that this product is suitable for the intended use. Because of atmospheric conditions, applicator competence and surface conditions being independent of the manufacturer’s control, we limit our liability for one year following the date of purchase, with proof of purchase, to replacement of defective material only in its original hermetic container. Port paid factory (FAB factory).