Plastic Cement — Winter Grade CR-20W
The CR20W is a winter grade plastic cement specially designed to maintain an easy trowel application during colder periods. This multi-purpose product is used to stick asphalt shingles, to seal cracks and holes on foundations and on asphalt roofs. It also seals chimney, vent and shingle flashings.
Do you want to buy this product?
Function
Stick / Repair / Seal
Building components
Roofing / Foundation
Surfaces
Asphalt shingle / Concrete / Metal / Wood
Coverage
0,32 m²/kg applied 3 mm thick (1,56 ft²/lbs applied 1/8'' thick)
Color
Black
Application Temperature
Low temperature, a temperate product is easier to apply.
Service Temperature
-40°C to 85°C
Application Tools
Putty knife / Trowel / Glove
Surface Preparation
Surfaces must be clean and free of dust, dirt or other contaminants.
Application
During colder periods, keep the product in a temperate place to facilitate its application. Do not apply if rain is expected. To repair joints and cracks, firmly apply enough product in depth to fill all the cavities and close the gaps. Apply the product in a slight excess above the surface to avoid water accumulation. To glue back shingles, apply only 3 dots about 25mm (1 ") spread evenly over the shingle. Close the container after each use.
Drying
Allow about 4h for surface drying and about 48h for complete drying. The drying time depends on the application method, the ambient temperature, the surface and the thickness applied.
Restriction / Caution
Keep out of the reach of children. If the product is applied near a ventilation or air conditioning unit, take the necessary precautions to prevent infiltration of solvent odours toward the inside. Keep all open container or freshly applied product away from open flames, sparks or other sources of heat. For outdoor use only.
Cleaning
Mineral spirits
Storage
The product may be kept in its original sealed container up to 12 months after the date of purchase by the user.
- 13,6kg
- 20kg
5 years limited warranty when installed and / or applied as recommended by the manufacturer. We will replace the product with a manufacturing defect. Under no circumstances will the manufacturer be liable for any amount exceeding the purchase price of the product used. The consumer must ensure that this product is suitable for the intended use. Because of atmospheric conditions, applicator competence and surface conditions being independent of the manufacturer’s control, we limit our liability for one year following the date of purchase, with proof of purchase, to the replacement of defective material only in its original hermetic container. Port paid factory (FAB factory).