Elastomeric Asphalt Emulsion Membrane CR-760 Condor-Bloc
CR-760 Condor Bloc is a polymer enhanced, single component asphalt emulsion membrane designed for below grade waterproof ing of foundation walls and other structures Solvent free, it has excellent adhesion to most construction surfaces such as concrete, brick, wood, metal and stone. CR-760 can be applied in a single layer or multiple with reinforcement fabric.
Do you want to buy this product?
Advantages
- Seamless elastomeric membrane
- Solvent free and environmentally friendly
- Very flexible
- Retain flexibility over a wide temperature range
- Excellent adhesion to most construction surfaces
- Can be applied to damp or green concrete
- Can be applied in one coat or multiple coats with reinforcing fabric
Function
Waterproof
Building Components
Poured and block foundation walls / Insulated concrete forms / Footing and split slab floors / Retaining walls
Surfaces
Concrete / Asphalt Shingles / Brick / Metal / Wood
Coverage
0.910 L / m² applied 1 mm thick
134 m² / chaudière de 18.9L
(At temperature 20˚C)
Color
Black (once dried)
Application Temperature
10°C and above
Service Temperature
-40°C à 60°C
Application Tools
Paint brush / Roller
Surface Preparation
All surfaces must be sound, dry, clean and free of dust, dirt or other contaminants. Fill the formwork tie holes with mortar or bituminous roofing cement and allow to dry. The concrete surfaces must be free of sharp edges, voids or flaked areas.
Application
Do not undertake any work if rain is forecast or if the ambient and substrate temperatures are below 5°C within the next 24 hours. Stir well before application. The product does not require any dilution. Try the product on a small surface to validate if the product is suitable. At the time of application and for complete drying, the temperature should be above 10 ° C. Apply the product using a brush, roller or paint brush. Clean tools and equipments with mineral spirits after use. The covering rate may vary depending on the application method, the applicator’ skills, the surface porosity and the temperature. One coat is sufficient, but if a second or more coats are desired, you must wait 15-30 minutes before applying the next coat. Protect the surface if drying is not complete before the dew falls, or if rain is likely to happen. Close the container after each use.
Drying
Sufficiently dry to walk on after approximately 30 minutes to 1-2 hours. Completely dry within 12 to 24 hours. Drying time depends on the application method, ambient temperature, surface area, and thickness applied.
Restriction / Caution
Cleaning
Mineral Spirit
Storage
Store this product away from frost. The product can be kept in its original, tightly sealed container for up to 12 months after the date of purchase by the user.
- 18,9L
- 205L
5 years limited warranty when installed and / or applied as recommended by the manufacturer. We will replace the product with a manufacturing defect. Under no circumstances will the manufacturer be liable for any amount exceeding the purchase price of the product used. The consumer must ensure that this product is suitable for the intended use. Because of atmospheric conditions, applicator competence and surface conditions being independent of the manufacturer's control, we limit our liability for one year following the date of purchase, with proof of purchase, to replacement of defective material only in its original hermetic container. Port paid factory (FAB factory).