Fibered Foundation Coating CR-64
The CR64 is a fibered coating for foundations. This product allows effective waterproofing of foundations made of concrete and masonry. The presence of fibers gives it strengthened resistance.
Do you want to buy this product
Function
Waterproofing
Building Components
Foundation
Surfaces
Concrete / Masonry / Metal
Coverage
1 to 1,5 m²/L (40 to 60 ft²/gallon)
Color
Black
Application Temperature
10°C and more preferably. The product will be thicker when the temperature decreases.
Service Temperature
-40°C to 85°C
Application Tools
Roller / Brush
Surface Preparation
Surfaces must be clean and free of dust, dirt or other contaminants. For the waterproofing of a new foundation, first seal the gap between the footing and the wall foundation using a bead of plastic cement from Condor. Use the same product to fill holes, cracks, weak spots in the foundation and the tie rod.
Application
Do not apply if rain is expected. During colder periods, keep the product in a temperate place to facilitate its application. Stir well before application. Apply the product in an even layer. Let dry completely before covering or backfilling to avoid premature product deterioration, thus allowing moisture to infiltrate. Close the container after each use.
Drying
Allow about 4h for surface drying and about 48h for complete drying. The drying time depends on the application method, the ambient temperature, the surface and the thickness applied.
Restriction / Caution
Keep out of the reach of children. If the product is applied near a ventilation or air conditioning unit, take the necessary precautions to prevent infiltration of solvent odours toward the inside. Keep open container or freshly applied product away from open flames, sparks or other sources of heat. For outdoor use only.
Cleaning
Mineral spirits
Storage
The product may be kept in its original sealed container up to 12 months after the date of purchase by the user.
- 18,9L
5 years limited warranty when installed and / or applied as recommended by the manufacturer. We will replace the product with a manufacturing defect. Under no circumstances will the manufacturer be liable for any amount exceeding the purchase price of the product used. The consumer must ensure that this product is suitable for the intended use. Because of atmospheric conditions, applicator competence and surface conditions being independent of the manufacturer’s control, we limit our liability for one year following the date of purchase, with proof of purchase, to replacement of defective material only in its original hermetic container. Port paid factory (FAB factory).